Sign in to follow this  
doc harper

1941 packard 110 4 dr. sedan

Recommended Posts

I need the drivers side rear mud/ splash guard, and also the short body welt moulding that goes on the drivers side cowling in front of the door and one tail light bezel that be used as a driver stuff doesn't have to be in new condition. something steel wool can clean up and as long as the bezel has the top tab. call tommy at 970-403-4935

Share this post


Link to post
Share on other sites

The rubber splash shield on the leading edge of the rear fender is only on vehicles with the running board delete option, but is I believe common to 1900-1901-1903 series (110-120-SWB 160).

 

The belt molding piece on the cowl is also common to at least those three.

 

The rocker molding looks like it is the same as the running board vertical edge molding but it's not.

 

Remember that your car has a shorter hood than but a common body with the 127" wb eights.

Share this post


Link to post
Share on other sites

the splash/mud guard is metal not rubber. it is behind the rear wheel and it bolts to the frame and to fender. flat metal with a x stamped in it for reinforcement. 1941 110 4 dr sedan

Share this post


Link to post
Share on other sites

the splash/mud guard is metal not rubber. it is behind the rear wheel and it bolts to the frame and to fender. flat metal with a x stamped in it for reinforcement. 1941 110 4 dr sedan

Those are reproduced. I see them on ebay from time to time. Someone in Washington, I believe, has them.

  • Like 1

Share this post


Link to post
Share on other sites

John Ulrich has some repro mud guards.  Is one of them the piece you are looking for?   http://julrichpackard.com/hood_parts.ht

 

John Ulrich has some repro mud guards.  Is one of them the piece you are looking for?   http://julrichpackard.com/hood_parts.htm

 

john  has the right side mud guard but no left. I found a sheet metal shop that says they can make one close to original. thanks

Share this post


Link to post
Share on other sites

I wish I would have known the early models would have worked. I had a shop build one even with the x reinforcement and looks nice. thanks for your help. I still need the left side belt molding that goes in front of the left front door on the cowl.

Share this post


Link to post
Share on other sites

I don't mean to be flip with this, but there was a factory mirror (even harder to find) that replaced that cowl trim SS piece, and that would solve the issue also..  I also had to search for the exact piece you seek.

Share this post


Link to post
Share on other sites

jon out in ca. has those s/s mirror brackets that go in place of the short belt molding I'm looking for but I have two holes right above this part in the w/s pillar post and that is where I'm going to put my mirrors. if I would have known about the molding replacement thing with the mirror bracket that would have worked and I could have filled in the two holes on each side of the windshield pillar. I may go ahead and get the brackets and get holes filled in if I can't find the molding I need. thanks for your help

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this