Red Dawn Posted September 18, 2015 Share Posted September 18, 2015 Has anyone converted their non-GS 65 rear end differential to a positraction set-up? If so, how much work is involved/ Thanks much for any advice. Mark Link to comment Share on other sites More sharing options...
John Posted September 19, 2015 Share Posted September 19, 2015 Easiest way is replace the whole dropout center section. Disconnect driveshaft at pinion gear, pull axle shafts back from center section, un-bolt and remove old center section, bolt in new center section, slide axle shafts back in position, re-attach driveshaft. Link to comment Share on other sites More sharing options...
Red Dawn Posted September 20, 2015 Author Share Posted September 20, 2015 Thanks for the reply back. Rearend is not in the car yet so, this should not be too bad of a project. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now