Jump to content

Dies when I let off gas pedal


Recommended Posts

I have a 1990 TC with the 3.0 engine.  It runs fine but sometimes it dies when I let off of the accelerator.  It will start again without a problem but it is a bit dangerous to have the engine die.  I am also wanting to speed up the idle but I am not sure how to do it on this engine.  I do not see the typical idle screw.

Link to post
Share on other sites

There is no idle adjustment screw on your 3.0 Mitsubishi engine. The idle speed is controlled by an electronic idle speed motor which is controlled by the engine controller. Maybe you should be checking for any fault codes in the system. Any Chrysler Dodge dealer can check for fault codes. in the past I have found a poor electrical connection at the idle speed motor in the throttle body. Bob Barrow

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...