Jump to content

Rear light


Recommended Posts

The light that sits on the back trunk. how do I get into it to change the bulb

Raise the Tonneau cover, look for the two screws that hold the lamp assembly on. Remove the screws, lift the lamp, disconnect the wiring connector, and you can get inside the lamp to change the bulb.

John

Link to post
Share on other sites

The retaining screws are under the rubber lip seal. You'll need to peel that back. If all the bulbs are out then the wire connecting eyelets on the circuit board should be removed and replace with small brass or stainless bolts and nuts.

Link to post
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...