Sign in to follow this  
George Albright

1900-10 planetary transmission & chain drive rear axle. Also Curved Dash Olds parts. Leads?

Recommended Posts

Hi everyone. I am helping 2 friends with their early projects. One needs a 1900-1910 planetary transmission to go on his hit and miss automobile engine. He also needs some Curved Dash Olds engine and trans parts and a real or repro CDO flywheel. Another friend needs an early chain drive rear axle for his project. They can pick up at Hershey if necessary.Leads appreciated! George Albright,Ocala,Fla. email gnalbright@gmail.com cell 352 843 1624 from 10-4 weekdays

Share this post


Link to post
Share on other sites

George, I still have the chain drive rear end and a couple of large flywheels from a 1 cylinder Reo. Can bring to Hershey. 518-755-0986

Frank

Share this post


Link to post
Share on other sites

Frank, I am one of the two people george is helping. I am building an Olds Pirate Racer replica. Need an 18 " flywheel and a planetary transmission from a CDO. I will chain drive the car just like the orig car, also just like the replica Steve Moskowitz built. Can you send pictures ?

Thanks,

Bob Ferry

Louisville, Kentucky

Share this post


Link to post
Share on other sites

PM sent, I'll take a photo of the flywheel later today.

post-30765-143141976741_thumb.jpg

Share this post


Link to post
Share on other sites
PM sent, I'll take a photo of the flywheel later today.

Frank, I do not think the axle will work for me, but I am interrested in the flywheel . I will check later when you post a photo.

Thanks,

Bob F.

Share this post


Link to post
Share on other sites

Frank thanks for getting with Bob. He needs the flywheel. Can you send him photos of both sides of the flywheel,and the diameter,and either email to me or post here. Thanks for helping Bob. The chain drive axle might work for my other friend,but its a stretch. Best he can do is $1,000 for it,if he decides he wants it. thanks again! George

Share this post


Link to post
Share on other sites

Let me chew on it a bit. If I stub my toe on it one more time, it just might be his....

Here is the flywheel. Need two???

Frank

post-30765-143141977541_thumb.jpg

post-30765-143141977546_thumb.jpg

Edited by oldford (see edit history)

Share this post


Link to post
Share on other sites

The pictured chain drive axle is actually the jack shaft for a 1910 or so 1 cyl REO truck. The plates out near the ends fasten directly to the frame. There are gears (one is there) that drive chains back to a double chain drive rear axle.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this