D-a-n-i-e-l Posted June 12, 2013 Posted June 12, 2013 Anyone have access to the equipment to make a custom axle shaft?I am spread thin with all the projects going on and would like to get one made for $100 or less. Everyone want three times that.Shaft would be 23.25" long splined on each side with three cutouts for snap rings and roughly 1.25 " thick
Guest crazytrain2 Posted June 12, 2013 Posted June 12, 2013 Daniel,I assume you already have an axle which is either to long or to short. If so, could you cut it into 2 pcs. (remove some length if to long) and make a sleeve (ex. 1.75" OD x 1.25" ID)-which the 2 cut ends fit into and you could pin and weld? or would torque requirements be a problem. You could probably get that done for <$100 Just a thought
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now