Jump to content

Model A Ford Parts For Sale


motoringicons

Recommended Posts

-Nice original pair of engine pans. These go between the engine and frame and are always missing or rusted out, and the repros. do not fit worth a darn. These need a little easy repair to the mounting ears on the engine side, but are nice and clean and should clean up without any pitting or use as-is on an original car. There is still some original paint left.-SP:D

-Original "seamed" inside and outside gas lines and the fuel shut off. They are nice and straight with good original fittings and the valve turns freely but could probably use re-packing. These original lines are a must for show cars as the repros won't cut it with the judges!!! 50.00 for the set of three plus shipping.-SOLD

-Nice original Duolamp Taillamp Assembly. Has taillamp, license bracket, fender bracket, both lens, sockets, etc. Nice original or old paint. Great for an original "survivor" car or could be restored. The red lens has a crack but a new, reproduction is included. 40.00-SOLD

-Old reproduction rear spring spreader tool for removing and installing Model T or A rear springs, has guides that slip over the axle housings to keep in alignment and tapered ends that fit on the spring eyes to hold firmly in place. Makes a challenging job a lot easier! 55.00-SOLD

-Nice original 10 leaf rear spring, correct for sedans, pickups, etc but will fit all years and models. No rust, the leafs are not worn into each other and the shackle holes are not worn. 85.00-SOLD

-Nice original front spring assembly. Missing the two top leafs (so there are 8 leafs now). Will fit all models, same condition as above rear spring. Great if you are making a hotrod or using 16" wheels on your car. 45.00-SOLD

-Nice original intake manifold, has small weld near carburetor. mounting, hardly visible. 20.00-Still Available!

-Reproduction intake manifold. These sell for 85.00 new, this one has never been used or mounted and is still in the original packaging. 55.00-SOLD

-Excellent 1928-29 headlamp bar, no pits, super straight, nice old paint. 35.00-SOLD

-Complete distributor assembly.Rebuilt using the Nu-Rex modern upper plate that uses modern points/condenser and the wireless lower plate. Complete with two piece shaft, new rotor, distributor body and cap. 85.00-SOLD

All prices plus shipping. Email for more photos if interested. PAYPAL accepted. Located in Ann Arbor, Michigan. Call 734-730-4274 or motoringicons@hotmail.com

post-31738-143141757243_thumb.jpg

post-31738-143141757252_thumb.jpg

post-31738-143141782451_thumb.jpg

post-31738-143141782461_thumb.jpg

post-31738-143141782471_thumb.jpg

post-31738-14314178248_thumb.jpg

post-31738-143141782488_thumb.jpg

post-31738-143141782497_thumb.jpg

Edited by motoringicons (see edit history)
Link to comment
Share on other sites

  • 2 weeks later...
  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...