rlcokc Posted February 7, 2013 Share Posted February 7, 2013 Had the reflector resilvered and ready to install. For the life of me can't figure out how the 3 spring loaded clips on the socket fit or how to get into the reflector. It is a 1936 Buick Special.The socket consists of the three springs with metal ball at end and a 1/2 moon clip. I assume the clip goes thru bottom of reflector and socket below on other side of reflector. Doesn't seem to be sufficient clearance to get the retaining clip to into the reflector and don't want to bend/break. Assume most of GM are same on the 193* era and maybe if someone has photo that would be helpful. Can someone give me direction/instruction? ThanksRod<!-- google_ad_section_end --> Link to comment Share on other sites More sharing options...
rlcokc Posted February 8, 2013 Author Share Posted February 8, 2013 Figured it out last nite--the half moon attaches on back of reflector to hold socket in place and the springs with bulb at end fit into reflecor to further hold socket in place. Link to comment Share on other sites More sharing options...
1937-44 Posted February 8, 2013 Share Posted February 8, 2013 Congratulations on figuring it out and thanks for the follow up. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now