Jump to content

Steering Column to Floor Seals for '65


kdml

Recommended Posts

I started with the ROA site and found a tech tip about making a seal to slip up into the column, to keep fumes from traveling up the column. I did not see anything specific about these seals. I will take another look

Thanks

Link to comment
Share on other sites

I would think that you could take a piece of HD rubber/foam and cut one for this. It looks pretty straight forward. Square, one big center hole, and four bolt holes. The only thing you might not be able to replicate would be the section where the ball shaped portion is; a plumbing roof vent seal might work for that ball shaped section.

Here are images of some that are available; most cost between $10 - $20.

https://www.google.com/search?q=steering+column+seal&hl=en&tbo=d&rlz=1T4GGRP_enUS503US503&source=lnms&tbm=isch&sa=X&ei=7XD9UKPbCuXS2gWei4H4BA&ved=0CAoQ_AUoAA&biw=1017&bih=477

Ed

Link to comment
Share on other sites

I did not have any luck finding something as a replacement for the floor seal. At this point, I have some leftover camper tape (goes in between a camper or cap and the bed rails of a pickup). I am going to try this, as it is spongy enough to conform to the floor and plate.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...