Sign in to follow this  
Danerg

Rubber carb to air filter elbow needed on 1952-56 Nash cars. Get on list to have it reproduced.

Recommended Posts

We are trying to find enough people that need this part so we can get it reproduced. Picture is below. Typically the bottom is hardened or rotted out from gas exposure. This is found on 1952-56 Nash cars. Email ambo49@gmail.com to get on the list.

Inside diameters carb side is 2 5/16" Air filter side is 3"

post-88038-143139244884_thumb.jpg

post-88038-14313924489_thumb.jpg

Share this post


Link to post
Share on other sites

Carburetor boots for Nash are difficult to find. There's a reproducer of the carb rubber boot for the 49 & 50 NashRamblerRubber.com that do a nice job. They are the same folks that mold the torque tube drive stabilizer trunnion for Nash Ambassador and Healey and Rambler through 62 or 63. Hudson from 55 -57 have the same drive line trunnion. They might have other years or be able to make a run if they have the molds. You should try coating your carburetor elbow boot inside and out with Protectant 303 or Armor All every month or so. It helps keep it soft and pliable, that is if its not too bad already. Careful taking it on and off the air filter.

Share this post


Link to post
Share on other sites

Yes. The email in my post is for Bob at NashRamblerRubber.com He agreed to reproduce it if we got enough people that needed it. It's a complicated mold so we need as many people as possible.

Thanks for the advice.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this