Heres a head scratcher!!

[Guest 6868C]

Since everyone was so helpful with the mirror question, heres another one. On this 41 Zephyr, on the forward door jambs (hinge end) there are holes punched into the jamb below top hinge and above lower hinge.(see photos) When it was dissassembled the piece in my hand(in pic) was the remnant(s) removed from the holes. They had a rubber washer shaped the same as the metal part shown with 1 medium sized slotted panhead screw holding it on. The question here is has anyone seen these on a car? Are they some type of grounding plate? Could be someone added these for whatever reason, and I will just have to repair the holes. Chris at Boos didn't recall such a piece either.

[Guest 6868C]

Dang,photos won't load!! Anyway, the metal piece is thin sheetmetal about 1-1/4" wide x 2-1/4 long with a small offset each way (from center) with 1 appx. 1/4" hole at center and 2 -1/8" holes very near that hole at a diaginal, and the rubber is same size. Thanks, Craig

[peecher]

Here's a pic of a '41 custom with vacuum wndow lifts. Are the holes in the forward door jamb of your car in the same location? These holes were the "pass- thru" for the vacuum window control hoses.

[keiser31]

Dang,photos won't load!! Anyway, the metal piece is thin sheetmetal about 1-1/4" wide x 2-1/4 long with a small offset each way (from center) with 1 appx. 1/4" hole at center and 2 -1/8" holes very near that hole at a diaginal, and the rubber is same size. Thanks, Craig

Try limiting your photo pixel sizes to 2000 pixels in both directions maximum.

[Guest 6868C]

here are the re-sized photos, thanks

[peecher]

Craig, someone may have tried to add "something"? here's a pic of a '41 Zephyr convertible

[Guest 6868C]

Peecher, your pic shows what I need, looks like someone did try to add something on this car. Oh well, little more touch-up to do! Thanks everyone. Craig