Jump to content

MAF Sensor


BrentS

Recommended Posts

So, I was getting E034 codes, and when it was happening engine would hesitate or stall (if it was at idle). I followed service manual procedure and checked the pins for the voltages, and they seemed OK. So, I installed a re-built MAF Sensor, but now the car seems to hesitate a little bit, right as you step on accel pedal from a stop. Other than that, car seems fine.

Is there an kind of re-set you're supposed to do (battery disconnect)? Does the ECM need to "learn" anything when replacing these?

Link to comment
Share on other sites

  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...