Jump to content

Oil pan guide bolts.


B1rdman
 Share

Recommended Posts

Gene, check your pan gasket set. Most pan gaskets I've seen have little tabs at the rear and these go under the ends of the rear cork seal over the rear main cap. You might have better luck spot gluing the pan gasket to the crankcase rail and then install the rear cork seal. You may also have to trim a bit off the front ends of the pan gaskets where they meet the crankshaft pulley seal area. You can pre-form the front rope seal after it's soaked in oil and intalled in the pan with a round bar or a large socket that is a little smaller than the diameter of the front pulley sealing surface. This will aid when trying to start those front pan attaching bolts. Good luck.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...