Greg in Maryland Posted February 3, 2009 Share Posted February 3, 2009 I am working on restoration of 1914 Metz and looking for any resource in wheel bearing cages and races. The balls are good, but I am missing some cages and several of the races are cracked. Any resources you might have to pass on to me would be greatly appreciated. Thanks. Link to comment Share on other sites More sharing options...
F&J Posted February 3, 2009 Share Posted February 3, 2009 It's been a long time since I had my 2 Metz cars, but I can't seem to recall a "cage" for the bearings. I was short some of the races for the front wheels and I know I ended up using some from a 17 front axle that I found locally. Metz used Ford designs on more than just the motor, as I used Model T rear brakes on one of mine....and even a T headgasket I had a couple of different Model T front hubs here recently and noticed they came in different sizes, so I really wonder if some certain-year Ford T pieces may imterchange? Long shot?, or maybe not.I used to buy from Langs Model T Parts in Ashburnham, Mass. He knows T's inside and out. I'd take some pics and measurements and email him...I think he is still in business....plus Metz was from his home state and I am sure that I was not his only Metz customer. Link to comment Share on other sites More sharing options...
Diners Posted February 3, 2009 Share Posted February 3, 2009 You may want to attend the upcoming history event at the Waltham Museum March 29th 2009 about Metz and Orient Automobiles.TRANSPORTATION HISTORY LECTURE AND DISCUSSIONhttp://www.walthammuseum.com/event.htm Link to comment Share on other sites More sharing options...
Restorer32 Posted February 3, 2009 Share Posted February 3, 2009 I would take careful measurements and check with your local industrial bearing supply house. There is likely a modern bearing that will do the job as well or better than the original. If the bearing has a # on it, so much the better. Link to comment Share on other sites More sharing options...
Dandy Dave Posted February 3, 2009 Share Posted February 3, 2009 I updated my 1915 Buick to tapered roller bearings and am very pleased. I purcased bearings from my local supplier that fit the axle and then machined sleeves to fit the cup and inner hub, and also installed modern grease seals. Tapered bearings by design put less pressure on the nut than ball bearings do and are easier to keep in adjustment. The front end does not shimmy like it did and this is widely excepted as an improvment on early autos. Dandy Dave! Link to comment Share on other sites More sharing options...
jim43 Posted February 3, 2009 Share Posted February 3, 2009 Greg; If you don't have one, call MSC Industrial supply @ 1 800 645 7270 or mscdirect.com and get their free "Big Book". My resource when I need a bearing or most anything by way of materials to make parts for 1914 Chalmers Master Six. When rebuilding my cork clutch I was a bit dismayed to find a failed brass bearing behind the clutch, which was really the root problem, as the clutch assembly is pulled against this bearing when actuated for shifting. I found one in the book, actually a better one, with two rows of balls. Problem solved and original improved upon. Nearly a three inch thick book. If you need it there is a good chance it is in there, usually with pictures. Good luck; jim43 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now