Guest Roger_Roy Posted May 31, 2008 Share Posted May 31, 2008 Hi all,Have been collecting DX45 bits for a while but information is a little thin on the ground here. What exactly are the differences on late '15 , early and late'16 D45 (and DX45) frames? As this is for a RHD export one all frames I have are right hand gear lever, 2 are gear lever inside handbrake outside of the chassis frame one is gear lever outside handbrake inside the frame section. I have rear frame horns that are part of the main rail and one that has the rear frame horn as a rivet on section ? I only have one frame number which is 166153, Im not worried about engine numbers just now but for info one chassis I have or (?) had was with engine DX6520, what I want to build is a early '16 DX45 , what should the frame look like?Thanks Roger Link to comment Share on other sites More sharing options...
Guest rlbleeker Posted June 3, 2008 Share Posted June 3, 2008 Mine has the gear shift outside the frame and the brake inside. The frame rails are straight at the back, and the gas tank mounts are cast and riveted to the rails. Based on the engine # it's a mid '16 car (on the early side maybe?). I don't have a frame #, but Dave Corbin estimated it at 165480. Link to comment Share on other sites More sharing options...
Guest DaveCorbin Posted June 3, 2008 Share Posted June 3, 2008 Dear Roger: The frame number of 166153 was issued to a 1916 DX45 per the Buick factory records. This would make it the 1258TH of 4741 DX45's built in 1916. The range of engine numbers that would be factory installed range from 164732 to 176731, so if one of your engines is within this range (or slightly outside of it),go for it. I hope this helps. Regards, Dave Corbin Link to comment Share on other sites More sharing options...
Guest Roger_Roy Posted June 4, 2008 Share Posted June 4, 2008 Mr Corbin, Im sure I speak for all Buick nuts when I thank you for your tireless work with Buicks! thanks for the information its much appreciated. RegardsRoger Link to comment Share on other sites More sharing options...
Guest DaveCorbin Posted June 4, 2008 Share Posted June 4, 2008 Dear Roger: I guess I should have been a Aussie. My dad was Mr. Corbin, I'm just "Dave" to everyone "down under" (your place) and "up top" (USA & Canadians). Seriously, the working with the numbers is fun and my contribution to helping get the restorations right. I hate to see a guy or gal put in a ton of work and get it wrong, or spend good money on the wrong parts. I've done both and wasn't happy about it. Regards, Dave Corbin Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now