Search the Community
Showing results for tags 'brake pedal'.
Howdy folks! I've been searching around here and VCCA with no luck finding tips on this. I have the master cylinder out of the car, but I cannot figure out how to remove the shaft that the brake pedal pivots on. It's a manual, so the clutch pedal slipped off after pulling the lock ring with no troubles, but it looks like that shaft is held in by a small ~3/16" pin. Do I just need to PB blast it and hammer it out, or is it a screw of some kind? The top side is flush with the cylinder casting, but the bottom is recessed a bit and I can't tell if there's a slot or anything to unscrew it, even after cleaning. Thanks in advance!