lrg

Members
  • Content Count

    35
  • Joined

  • Last visited

Community Reputation

0 Neutral

About lrg

  • Rank
    Member

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. I would also be interested to know where the smaller pieces Go ("B" in the ad ) Says "fits on lower heal of fender well". Has anyone located them yet?
  2. Hi duk, 70 views and no answer huh . If you are still looking for removal instructions. I just happened to have done this before. (must be the only one) There is a set screw holding the bezel and lens on to the cluster . Remove it and the gauge face. The fuel gauge is bolted with 3 bolts to the printed circuit board behind it. I hope you haven't torn the dash apart trying to get to it from the back. let me know if you need any clarification, Lrg Larry
  3. So, The brackets in the picture. Are they the correct ones for a car with a fan shroud? And does anyone have the brackets for sale? including the upper one not shown. email lrg1965@aol.com Thanks lrg, Larry
  4. Hi Ed. yes I would like to add a shroud to a non a/c car. Do your lower brackets look like these?
  5. Hi I would like to buy upper and lower fan shroud brackets for 1963 Riviera Email lrg1965@aol.com Thanks Lrg larry
  6. Hi, I would like to know if the interior door panel mouldings (around the wood trim) (custom interior) can be removed without removing the panel from the door ? I would like to repaint the black stripe on them they are peeling Thank you LRG Larry
  7. wow!!!! That settles that . nice job with the pictures Jim that"s great!!!!!Thank you lrg larry
  8. I'm still confused. If the rubber hose in the pic goes to the metal pipe that runs to the barb near the bottom of the exhaust manifold. where does the tube covered with white insulation that's attached to the choke housing go? anyone else have any other pics that would answer that question Thanks lrg larry
  9. jim, is that rubber hose pass side rear top of carb going down to the exhaust manifold?
  10. Hi, Does anyone have a picture of the pass side of a restored or original engine compartment? I would like to see how the heat tube for the choke looks and how it attaches to the carb (what the fittings look like) thanks lrg Larry
  11. anyone know what parts of the 4door shaft i can use on the 2 door ? Thanks LRG larry
  12. Kevin rivgs, Thanks for the info it was spot on except for the riviera script. It used push clips similar to the clips holding the horse shoe moldings on except they are round. Everything came off with no damage. Does anyone know where I can buy any of the clips that hold any of these moldings on. It would be nice to replace the iffy ones Thanks all LRG Larry
  13. I'm not currently in possession of that manual right now
  14. How do you remove the riviera script mldg on front fender? and the stainless strip on the lower fender and quarter panel? I dont want to damage it Thank you LRG Larry