red ram

It is a 53 dodge.

I have a tank that has pin holes. i would like a new one or a NOS. were should I look? If they do not exist how do I repair the one I have?

Thanks but steele rubber does not have them either.

I am having trouble getting vent window rubber for my 53 dodge. Andy Bernbaum does not have it. Any options? any rubber I can substitute even if I can not open the wvent window? Thanks

I am having trouble getting vent window rubber for my 53 dodge. Andy Bernbaum does not have it. Any options? any rubber I can substitute even if I can not open the wvent window? Thanks

My 53 Dodge restoration had 710-15 as the original tires. I want to get as wide a white wall as possible. In 4ply bias I have found acceptable tires from Goodyear, BFGoodrich and in 6ply from Lester. I know nothing about Lester. In radial Diamondback has a 215/758 15 but the white wall is 7/8 to 1 inch narrower. I know nothing about Diamondback either. I might accept the narrower WW if the difference between radial and bias ply matters. Any advice? Have any of you had good or bad experiences with Lester or Diamonback? Thanks Stan

I am looking for a NOS gas tank or one in good condition. If I do not find one any suggestions what I could substitute. Thanks Stan

I have a 1953 Dodge with the 241 Hemi. wha twas the factory paint job on these? I see in the literature that the engine is multi-colored.

32-ML-119138-ML- Sent to Chrysler Forum RWB

I have a 1953 restoration going. does anyone know what the factory color was for the 241 Hemi that the car was equiped with or how to find out?

In an ad in saturday Evening Post from 53 the Coronet is shown with bright metal drip rail trim. Some people say it did not have this trim. does anyone remeber if they ever saw one with the trim? If so, how would I get it now?

I am looking for leaf springs for a 53 Dodge. Either new or NOS.

does anyone know if chrome drip rail molding is available for a 1953 Dodge? Thanks

I need a floor pan for my 53 dodge. Does anyone know if they are available or will I have to fabricate one? Thanks

I have a 53 which I have finished the frame off and sent to the sandblaster. So it must be time to get rubber parts. I called Steele Rubber only to find out that old rubber parts for Mopar are very hard to find. the guy they would have recommended had a heart attach at a show last year. Any advice what I do now other than sell the thing for parts? I also just sent the Hemi out for rebuild. I am into this for some bucks.