1951DodgeConvert

I also have a post made in that board, but still no luck. Thanks, Alex

Hello, I am trying to find the schematic diagram for the mopar 812 radio that is in my 51 coronet. The following web site should have it but I cant seem to find the Philco equivalent. http://www.nostalgiaair.org/Resources/ does anyone have it handy to email or post? I am particularly looking for the capacitor values in the radio. Thanks Alex

Hello, I am trying to find the schematic diagram for the mopar 812 radio that is in my 51 coronet. The following web site should have it but I cant seem to find the Philco equivalent. http://www.nostalgiaair.org/Resources/ does anyone have it handy to email or post? I am particularly looking for the capacitor values in the radio. Thanks Alex

Opps, a typo. I was looking to say 5500. correct only 5550 were only made.

I too own a 51 coronet convertible and would love to compare noets. I understand that only 500 were built which makes this care very very rare car. please send me a note via email at avezbakiyev@yahoo.com Alex

good point. perhaps if I make the copper softer it will work. lll give it a try.

Thanks, if someone has ideas of a local place please let me know. Monroe NJ

not sure if picture uploaded. here it is again.

Hello Perhaps someone can point me to where I can by the copper washer that goes between the master cylinder body and fitting nut. this is for a 1940's mopar (Plymouth). I have searched the local auto parts store, Home depot, lowes and plumbing supply with NO luck. please see attached photo. I understand brass and Aluminum would also be acceptable. Any thoughts or ideas would be appreciated.

Hello, I am trying to finish my 51 coronet convertible, and need help with the top top. The guy who had the car before me toke off the original top and did not take pictures. I tried the shop manual and parts book, but they don?t have much. Any chance some one knows of someone with the same car? I am really desperate for a few pictures, particularly along the sides and back. Because this car is very rare (only 5500 produced) I can?t seem to find any pictures on the internet. Where else should I look? Is there a dodge historical association? Would they maybe have pictures? Please excuse, me I also posted the message in the dodge section. Thank you Alex

Hello, I am trying to finish my 51 coronet convertible, and need help with the top top. The guy who had the car before me toke off the original top and did not take pictures. I tried the shop manual and parts book, but they don?t have much. Any chance some one knows of someone with the same car? I am really desperate for a few pictures, particularly along the sides and back. Because this car is very rare (only 5500 produced) I can?t seem to find any pictures on the internet. Where else should I look? Is there a dodge historical association? Would they maybe have pictures? Thank you Alex