Jump to content

johnworden1

Members
  • Content Count

    403
  • Joined

  • Last visited

Everything posted by johnworden1

  1. From experience I can recommend Wrights Custom Chrome in Grafton Ohio.
  2. I made this crank hole cover.
  3. My questions concern the floor beside the seat base. Does the floor mat extend rearward along the seat base to the B piller? The gusset at the B piller/floor junction has 2 screw holes in it that appear to be factory. Is the gusset covered with something? At the door sill where does the interior grey color terminate and the exterior cab color begin? Thanks John Worden
  4. Restored and winner of all major AACA awards. Car is located in Florida. Red/red/black top. Best offer. Thanks John
  5. From experience I will confirm Dave is a stand up guy. He has been very willing and helpful in the restoration of a 37 DB in my shop. He has a life outside of work and supports local volunteer fire departments. In case you don't know they have been extremely busy lately. I recommend him without reservation. John Worden
  6. I have added more photos since your post. I'm happy to answer any detail questions. Sorry but $5000.00 won't buy it. The car is in the Ft. Myers Florida area. (wish I was there today)
  7. The car will sell for less than the $100,000 + restoration cost. Offers considerd low will be politely refused. Viewing the car can be arranged. Thanks. John
  8. I could build a complete electric truck using this chassis or advise how to do it.
  9. AM radio unknown voltage. 3 section antenna and cable included. Top end of lower section damaged. I have not tested it. Can have it tested and repaired if need be. Push buttons and dials work. Removable push button covers shown in top of radio. Some pitting on pot metal. $25 plus ship Thanks. John
  10. Mr. Smits I have PM'd you. Thanks. John Worden
  11. Multiple AACA awards winner. Pics available for serious consideration please. PM me or call 641 474 2313 home and shop in Iowa. Car is in Florida. Thanks. John
  12. I have a 53 Olds 98 Convertible available selling for a friend. It has won many major awards and is located in Florida. I have more pics. PM me or call 641 474 2313 home and shop Thanks. John
  13. Need complete set of seats for 1950 Merc. 2 door Thanks John PM me or call 641 474 2313 home and shop in Iowa Distance most likely not an issue.
  14. The kit showing 4 self locking nuts below 9 brass nuts.
  15. AMS has a partial installation kit showing 4 self locking nuts. That's why I ask.
  16. Ok thanks. Are 4 self locking nuts used with the 4 thick steel intake washers? If not, where? John
  17. I'm fairly certain that 4 of these brass spacer/washers were used to bolt the Ex/Intake manifolds to the 37 block. Notice that the interior ID is tapered. Where are they used? Thanks. John
  18. They fit between the brake backing plate and the end of the axle housing outside of the bearing.
  19. I've read all the posts and thank you all for them. I will measure everything again today to confirm that the measurements fall within those listed in the Motors Manual. The manual also specifies equal shim thickness which I have gained. If all is good I will fit the shims and backing plates and measure end play again. John
  20. Thanks guys for the help. Today I was able to get .003 end play one side and .007 the other which is just within tolerance. The manual says to have equal shim thickness both sides. As of today I need a .036 shim both sides. I have 2 .030 shims and will most likely make the rest. John
×
×
  • Create New...