-
Posts
450 -
Joined
-
Last visited
Content Type
Forums
Gallery
Events
Everything posted by jazzer3
-
From the album: Studebaker
rusted body mount -
From the album: Studebaker
In the garage since 1977 -
57 Studebaker Commander 4 door sedan
jazzer3 replied to jazzer3's topic in Studebaker, Erskine & Rockne
Some before and after shots of the roof and hood, the hood still needs waxing getting there slowly. Jay -
57 Studebaker Commander 4 door sedan
jazzer3 replied to jazzer3's topic in Studebaker, Erskine & Rockne
After buying seam sealer and undercoating to finish the job a spot just below the firewall insulator looked suspect so the tools came out and a piece 3 inches by 8 inches was welded in. I didn't grind any welds smooth as they were solid and looked good enough to me with a little dressing. Now the interior gets a good cleaning and put back together. Jay -
57 Studebaker Commander 4 door sedan
jazzer3 replied to jazzer3's topic in Studebaker, Erskine & Rockne
The body mount is only 1/8" and not 3/16" as I posted yesterday and the piece used for the floor measured .072". I got a good weld along the pinch weld just in front of the door and tied as much surrounding metal as possible into the body support Not exactly factory but strong. -
57 Studebaker Commander 4 door sedan
jazzer3 replied to jazzer3's topic in Studebaker, Erskine & Rockne
Some rust repair was necessary and I needed to see, a four foot florescent light suspended on ropes works well. Seeing is not a problem, here is what needs fixin. The new mount is welded in but the bottom of the new mount is made from one piece of 3/16" steel verses the original which appeared to be two pieces of thinner stock. Had to rush home so no photos of what got done yesterday but it was a good day of progress. I wasn't sure what i was going to use to replace the mount but there is quite a pile of cut-offs that are kept for these problems. A short piece of 2" X 4" steel tube cut up provided the uprights for the mount. The rounded corners of the tubing closely match the radius of the original mount. Jay -
From the album: Our Cars
-
The Carburetor parts I'm working with April 12
jazzer3 posted a gallery image in Members Albums Category
From the album: Our Cars
-
May 5, 2013 Start Transmission And overdrive investigation
jazzer3 posted a gallery image in Members Albums Category
From the album: Our Cars
-
March 12, 2011 36 trans assortment And other parts
jazzer3 posted a gallery image in Members Albums Category
From the album: Our Cars
-
From the album: Our Cars
-
The problem Was with The float valve And Not dirt As I thought
jazzer3 posted a gallery image in Members Albums Category
From the album: Our Cars
-
This Is A fuel tank from My first race Car taped To The front bumper
jazzer3 posted a gallery image in Members Albums Category
From the album: Our Cars
-
From the album: Our Cars
-
July 12, 2013 under power first time Out Of The garage
jazzer3 posted a gallery image in Members Albums Category
From the album: Our Cars
-
C 10 engine almost ready For insallation May 19, 2013
jazzer3 posted a gallery image in Members Albums Category
From the album: Our Cars
-
From the album: Our Cars
-
From the album: Our Cars
-
1 cleaning The water jacket taken Feb. 15, 2013
jazzer3 posted a gallery image in Members Albums Category
From the album: Our Cars
-
From the album: Our Cars
-
From the album: Our Cars