vincejs

it has been a long time since i looked at the site. have done that, but the cylinder must be wedged, does not slide. thans very much for the directions. vince

where can one get a replacement muffler for a 1926 dodge brothers. 2" in 1 3/8 out

this is the 2" knut that hold th e exhaust pipe to the manifold. vince

where can you get nickle plated machine screws? vince jschifano@cox.net

have two hubcaps slightly less than 2-3/4" at thread end. they are in good every day condition, not show, $15 each. also have one with a 1-1/2 thread dia. e-mail jschifano@cox.net

WHAT IS THE SIZE AND THREAD PITCH. WHO HAS? VINCE OSTEL@SHC.ORG

possible places to try vintage supplies ltd www.vintagesupplies.com tel1692650455 ficken wiper service 631.587.3332

looking for arizona 1927 license plate. please respond to jschifano@cox.net

BY REMOVING THE 15 SCREWS ON THE TOP THE TANK COMES APART IN THREE SECTIONS, THE TOP WITH THE VALVES AND FLOAT, THE INNER TANK, AND FINALLY YOU ARE LEFT WITH THE OUTER TANK. CLEAN AS NECESSARY WITH CARB CLEANER. THE CORK GASGET WILL PROBABLY FALL APART. BUY A PIECE OF CORK SHEET AT A HOBBY STORE AND MAKE A NEW ONE. VINCE

is there someone making brass spring shackle bushings for 1926 dodge. vince schifano jschifano@cox.net

where can i get a 4.5x21 tube with a right angle stem?

i have two lenses need dimension stamped on top and also the part #. reply to jschifano@cox.net

www.gaslightauto.com

romar titusville, pa. has dodge parts 814.827.7601

water pump believe for models with starter/generator. casting # A3708, A3709, THIS UNIT mounts directly to the block with two bolts. corner of one bolt hole broken. this unit has two grease cups, one missing. shaft length are , input side 6 to 7 inch long, output side about 1.5 inches. asking $25 plus ship. jschifano@cox.net