63 RIV MOE

Tom. I'm not too swift on these forum searches. I can't find 63RIV (Bill). Can you help me contact? Thanks, Mike

I want to put a fan shroud on my 63 (non-AC car). I need the brackets to do so. Any sources would be appreciated. Thanks guys.

Looking for a good passenger side exhaust manifold for my 63 401. No air, if that makes any difference.

I am looking for the left, right and center AC dash outlets for my 63. I assume they are the same for 64 and 65. Any help would be appreciated. Thanks.

(63 Riviera) Having a hell-of-a time putting in new rubber from Steele. The original quarter window w-strips have a metal strip molded in to make them easy to install. New ones have no backing. Lots of Dawn used. Got one in, but had to cut one of the little channels deeper so it would finally , slowly go in. Anyone have this issue? Or am I getting too old for this sh*t? 😉 Still got one more to do.

I would like to put 4 halogen lights on my 63, but have heard about possible problems with the high heat from the bulbs effecting the wiring and drawing too much power. My car has 65K miles and all original wiring in good shape. Thanks guys.

Norther Arizona October 2022

No ultra judging. Just close to original T-3.

I need to know where to find the 4 headlights for the 63 Riviera. H5006, and H5001 with the same glass pattern as original, or close. Set of 4? Thanks.

I'm considering a Vintage Air system for my 63. I see a trunk mounted unit available that blows cold air through elbow vents from the package tray. This seems like a much easier install rather than going into the dash with all that hardware. Has anyone done this? If so any issues with the install or cooling?

Still having trouble accessing the rear of the Sonomatic in my 63. How do I remove the face panels around the face of the radio? And do I need to go thru the glove box?

I need to remove the Sonomatic AM radio from my 63 Riv. The service manual says to remove the "trim panel" to access the rear of the unit. After removing all the push-pull knobs and trim panel there is no access. Thru the glove box does not look good. Anybody done this before? Thanks.

I'm having trouble finding the correct gasket for the thermostat housing on my 63 Riviera 401. 3" OD, 2-1/4" ID, 3-1/8" between hole centers. Thanks guys.

That's the ticket. I'll just have to add a small speaker under the dash somewhere. Never will cut anything. Thanks guys.

I have the Sonomatic AM radio in my 63 that comes on, but full volume at any knob position. Would like to repaire or upgrade with something with more than the one speaker, but keeping the original look. Is there room under tha dash for another speaker?