Ken Felton

Hello Dave, You have an excellent eye. That does look like a match. There were early Dodge and Plymouth parts in the same lot. I can measure the length tomorrow and post it. Thanks again for your reply. Ken

This came with a Ford parts lot but I can't find a bent line profile match on-line. Any clues what year and make of sedan this came from? Thanks in advance for your advice.

Thanks DR Watson and Dave Wells. I appreciate it.

Hello 55er, Thanks for the clue. I will research that

But I can't find any information about them based on this description. Any guidance is appreciated. Thanks

Hello Drwatson & Sage Finds thanks for sharing you opinion on the identification. JV Puelo - also thanks for sharing your experience using the jacks.

Hello, Advice on this jack. I can't read the serial numbers. Thanks Ken

Confirmed they are 1932 Chevrolet - Thanks again

Thank you Sagefinds. I will research your opinion to confirm.

I am not familiar with what car/truck this bolt pattern will fit either. Am I measuring this correctly? If someone can help me identify what car it will fit and/or goes to I would appreciate it. Thanks again Ken

I am not familiar with what car/truck this bolt pattern will fit. Am I measuring this correctly? If someone can help me identify what car it will fit and/or goes to I would appreciate it. Thanks Ken

Hello Keiser31 and Ply33, Thanks for ruling out Plymouth. Hopefully someone else can ID this Ken

Hi Mal, Thanks for reply but it is not Model A Ford. I have Model A Ford axles and it is not a match

This diameter of the king pin hole is 1" My other early Ford axles are 3/4" in diameter. The width between perch pins in similar. Center to center on the perch pins is 37", my other 32 Ford axle is 36 1/2" center to center so there are close. This axle has less of a "drop" than the 32. Any advice on what this axle & wishbones goes to is appreciated. Thanks

Hello Oldtech and Dr Watson I appreciate you getting back to me. Thanks Ken

Hello, This is probably a slam dunk question for most of this group, but all my research is showing me examples of this emblem V8-85 and not V8-60. I hope to get a better understanding. Thanks in advance for your time. Ken

This was labeled 36, and looks like it would mount to a Ford. Any opinions? Thanks

Hello Keiser and The 55er, Thanks again for sharing your knowledge with me. Ken

Hello, Thanks for looking. Ken

Hello Keiser31 thanks for the quick reply

Hello, Any body know what year this goes too? Thanks for looking

Hello 55er and Roysboystoys, Thanks for the advice. I will take your advice and do some disassembly to try find out some more information. Thanks again. Ken

Hello Tom, Thanks for the late reply. Thanks for the advice and opinion. I will do a little more research based on your suggestions. Ken

Hello Viv W, I appreciate the picture of your car and the confirmation. Looks great by the way! Ken

Hello Dave, Thanks for the picture. Very close without the crank hole. It is handsome looking radiator shell. Ken