Spalchanes

Hi @viv w. The switch works after many hours of trying to fix it from what the previous owner did. It works but is very temperamental thats why I was looking for a new rebuilt one because I don't know how long it's going to last. Thanks for the advice, Sarah

Does anyone know where I can find an ignition switch or can rebuild the one that I have? I am kind of at a loss. So close to finishing the car and getting it running.

I just got my motor back from getting some work done on it and I am trying to get the wire harness in but have hit a couple snags. Is there anyone that can help either with a better diagram or picture of there own cars wiring. I have the owners manual diagram and what was sent to me with the wire harness but I'm still having some trouble.

Thanks for the recommendations. I'll look into them. @leomara

I need to send my motor to get rebuilt. I am located in New Jersey. Any recommendations would be greatly appreciated.

Okay. Thanks for the information. @viv wand @stakeside

While I was putting my new flywheel on I realized that one of the bearings burnt out. Any suggestions as to where I can find another one?

I took the gas tank off today and something just doesn't seem right with one of the lines. It looks like it's been plugged. Can anyone tell me if that's normal.

Thank you for the info. This is all new to me. I really appreciate the help.

I am starting to work on getting my car together and I have a few parts that I'm not sure what they are. Any help would be greatly appreciated.

Thank you so much for the help

Thank you. Appreciate the help.

I have these 2 holes by the fedco plate. I'm not sure what goes here. Any ideas?

Thank you for the information. I will look into ynz tonight.

I am looking for a complete wiring harness for a 1926 chrysler G 70. I called Rhode Island wiring but they only had a wiring harness for a 1927 finer G70. Any suggestions?