George Waters

I would need all 16 for the for the front and 16 for the rear. Thanks George

does anyone know where to purchase the hub bolts for this truck? I know that i could use common carriage bolts,but the heads look wrong. The fronts are 7/16 diameter and the rears are1/2. Thanks George

How do these come apart to clean and replace the seals. Mine have lot of dirt and old grease in that needs to removed. Any pictures of these units to show how theyare assembled? Thanks in advance George

Looks really nice Paul.

Try Rapparts 477 Autumn leaves road starlight pa 18461 ph 570 798 0390 . I was there a couple years ago and he had a bunch of them in the barn. I was looking for parts for my u133 truck but he didn't have much that i could use. George

for thirty dodge panel. If you contact George Farrell at romar he may have a reproduction mirror mount like pictured. What is the length of the tube that holds the mirror I have the mirror and bracket for my u133 but not the correct tube. George?

try loosening #29 then adjust #25 you may get rid of more play. George

I have a 1930 u133 with a hannum 4 steering box. I had a local machinist put new bushings in for the output shaft the inner bearings were ok after cleaning. I don't have the truck running now,but hat is one thing that is fixed. George

If you can send me message or cell I may have a couple of those moldings. I could send a picture to your cell from mine. Your truck has the same fenders headlights as mine. My radiator and shell look like the one stakeside posted. George

Your truck looks very similar to my u133 1930 .Look on the rear header in the cab for a data plate which if it is like mine will have the model# and wheelbase on it. George

Where are you located and what steel part is missing? George

This is a 1930 u133 cab and dash. The door has four hinges and the opera windows are the same as my truck. George

The can is for my u133 dodge truck. I have repaired the holes but i would like to add a bit of extra security. George

What type of sealer can be used to seal pinholes in a brake fluid can? Eastwood said that their gas tank sealer would not work. I may try epoxy finish resin. I have repaired the hole etc.but I know if not sealed it will lea Thankyou Georgek again.