jmarti67

I’m having some trouble solving this and doubting my ability with electrical. Any Reatta pros or mechanics around Atlanta, Ga?

Original issue is when I turn the key there’s no crank no start - I put a push button to the starter solenoid and now it cranks sputters stalls. There’s no power getting to the starter.

Yes, key was in and turned for me to crank with the remote switch. Wondering why it quit as well...

Clipped on a remote starter to solenoid - cranked, started, stalled. What would keeping power to the solenoid? That power comes from the ignition correct? thanks to everyone that’s been following and responding.

I alligatored some clips to the starter stud and didn't get any voltage when turning key. I did get around 12v from the constant battery cable to starter.

Yes it was blinking before I closed the door

Lots of clicks/ticks from under glovebox. Relay? Module?

nope - I don’t see the security light at all when turning key

Flashing with door open and then goes off when door is closed

didn’t notice any dimming with the headlight

I picked up a starter after I got a failed results after one test. I'm going to put it on and see - if not I'll start looking for drops too.

I do remember now that my interior lights and headlights were flickering the morning I drove before it wouldn't crank. Putting on the starter tomorrow and I'll check again.

I’ll check this out when I put the starter back on. This would indicate the alternator? Would the alternator keep the car from cranking even with a jump? thanks.

Test from auto zone said starter was good What else is there to check?

Oh boy, not sure if my skill is up to that level but if it’s bad I may have a look