Lescor

interested in finding an original '34 Dodge owner instruction manual .. Any condition tx .. les

in need of an Ammco 1750 brake gauge .. please contact me at 408-201-3829 tx .. les

in need of an Ammco 1750 brake gauge please contact me at 408-201-3829 Les

Ian .. any suggestions about removing the front shocks .. and .. doing a rebuild .. ? my car is shaping up .. turning my attention the the brakes and suspension hood all is ok .. les

Ian: how did you approach the restoration of the “rubber” frame around the rear quarter windows .?? like most, mine is damaged and needs some repairs ., les

Thanx anyway

That’s a KC not a KCl. . Thx

Starting a ‘35 humpback restoration and could use a better frame thx ., les

Starting a restoration of a ‘35 Humpback and could use a better frame .. thanx .. les

Starting a restoration of a ‘35 Humpback and could use a better frame .. thanx .. les

Are these parts still available ? interested ... les 408-201-3829

I should say . Is it still available? les

Are you selling this ?? interested .. les 1934 dodge dr 4-door

overdrive for ‘35 dodge sought.. tx ..les

FRONT fender (sidemount) installation: looks as if I may do this solo .. can you provide as my advice as to a safe and good fitting? ... I may have to do this alone .. so wanna be careful my radiator shell is chromed and painted and the grill is ready to install maybe a few pointers ! tx .. les

Ian .. thx for the excellent pics .. they confirm my understanding .. and .. that I will need to chrome the windshield hinge brackets nice job on those thx .. les

Ian .. after hours of looking i finally figured out the exact mounts .. and was fortunate to find someone who had them .. very lucky !

looking for a pair of windshield mounting brackets (and hinges) for my 1934 Dodge sedan ... please look at pictures thx! les

Ian .. Do you have a picture showing how the windshield hinge mounts to the windshield frame the large flange seems to screw into the interior header area where the are two holes Spaced 2 1/4” apart .. that leaves the small flange with two holes to fasten to the windshield .. right?? tx .. les

Due to minimal clearance with the body the supporting arm might best be attached OUTSIDE the bumper bracket .. this may interfere with placement of the base cap and cover

Trunk rack support mounting: pictures should do the trick support fits without stress .. attached behind the bumper bracket .. les

Yes it as appears that the supports pictured above are the correct length and angle to bolt onto the bumper bracket and then bolt into the the luggage rack rod .. now I have to take the bumper off and see where it can attach with out interfering with the bracket cover plates .. and/or allowing the bracket covers to fit .. I think you know what I’m referring to .??:))) geez ..

Here are the two photos from original purchase .. not that it means they are correct .. ..

I checked the fitting and it seems they would fit near the end of the rod .. either inside or outside .. most likely outside ... where the rod goes thru the main bracket to me that makes sense since it would give the rack some triangular support and be permanent .. funny ...