demon452

Looking for the bracket that holds the column to the dash for a 56 special. Please send me a message with a pic and price. Thanks in advance Steve

Sry. I did say I had the other part. Was clueless as to where it went. It's all back together. Thanks for the pics.

Just found this. Is this the piece that connects the 2 in the center?

Ok. I have the 1 half your finger is pointing to. Apparently I am missing the piece that connects the molding. Does anyone have that piece for sale? If not I may just try and make 1. Thanks for the info

So I was installing my Lower molding and it seems like I am possibly missing a clip. I have the clips that are attached about the wiper. But was wondering if there is a center clip I am missing? Or is my molding just warped or bent, possibly bent brackets above the wiper shafts? I attached a pic. There is a hole but I dont know it that was added by someone else for some reason.Yes I do have the small center piece for the molding itself. Any help or if I am missing the piece a pic is greatly appreciated. Thanks, Steve

I am wondering if anyone has a different steering wheel and if so what adapter are you using and a part # you have 1. I have a 55 buick century and being tall I want a slightly smaller wheel. I already bought a gm adapter and it's to small shaft/splines. Thanks in advance

Lmao. Now that is funny.

Can anyone tell me where this goes? Or have a pic? Buick Door Lock Post Bumper - Upper Thanks

Looking to buy rear bumper brackets for my 55 century. Dont need all 6 just what I have pictured. Please send a PM with price and pics. Thanks, Steve

I am not against it but the cost may be a bit high for me. Compared to doing a swap. I can't recall what gear vendors was selling them for last time I check. But remember it was quite costly.

Why as in doing it? To add an overdrive transmission.

Plan on doing an open drive conversion. Will a 61/62 3rd member bolt Into a 55 housing? I know they will work with a 56. I understand if it works I would have to get new axles due to the splines. Thanks in advance

Perfect. Easy enough. Mine are cracked right before the come out of the column. Just didn't know how the switch itself was. Haven't taken apart yet. Thanks for the info. Steve

Does anyone reproduce a 1955 buick century turn signal switch? Or are they easy to rewire? I am rewiring my car and notice that they are pretty damn dry. Thanks in advance Steve

Just found an old post and figured it out.

Can anyone tell me how to remove the switch assembly. I dont want to break it. My horrible pic is from the backside. Thanks In advance Steve

Anyone have 1 for sale?

I have the L bracket. Just looking for the piece on the hood. Also want to know what its actually for? Thanks

Ok I know my hood does not have this but the bracket is still there. on the firewall. I am wondering what's it's purpose is (aligment)? Maybe someone has 1 for sale. Pic is enclosed and it's what Is circulated. Thanks in advance.

There was no connector. Solid wire. When I pulled my deck lid I disconnected the wire from the socket and pulled it that way.

I ask mainly because steel rubber wants $240 and metro is $130 for the same set of seals. Just seems like a big difference in price to me. I have used both in the past and didn't have issues. Just odd the price difference.

Just wondering if anyone has used "metro rubber" seals for the vent window and if so how did they fit? I have used steele rubber products and have had no problems with any of there seals. Just curious on metro rubber seals. Thanks in advance, Steve

Pretty good shape, some very minor pitting and skuffs. Only 1 clip is missing.If you have any questions send me an PM $85 shipped.

Looking for a set of rear bumper guards for my 55. Not interested in any that are dented. If they need rechromed that is fine. Please PM me with pics, condition and what your asking price. Thanks, Steve