Wisebri24

Members
  • Content Count

    19
  • Joined

  • Last visited

Everything posted by Wisebri24

  1. Morning do you still have this light? Or similar? Thx., Joe
  2. Suicide rear spring setup 1929 Ford Tudor sedan with V8 engine My rear 10 leaf spring set measures 41" from eye to eye. I am told I should allow 3" on each side to compress the spring set. Plus the shackles are 1-1/2" each. I am trying to set up a bare axle tube for perches. my calculations: 41" springs eye to eye 6" Spring compression 3" shackles 50" total perch eye to perch eye centers please advise thx.
  3. So the guy gave me a set of leaf springs with the purchase of my 1929 Tudor sedan frame. 10 leafs??? This thing will support my mother in law! How many leaf's are suggested for a Tudor sedan with a 57 nailhead?
  4. Mine is a R10B-1R. My research leads me to believe the R10B-1G has the same case.
  5. I have a 1941 Studebaker - R10 Borg Warner Overdrive set up in my torque tube on my 1935 Chevy. Driving on the highway with 4:11 gears and a 83 year old 207 engine was not an option. I use it only after 3rd gear and it reduces my rpm's by 30%. I use a switch on my clutch pedal to disengage the o/d's electric so I cannot back up in overdrive. It took quite some time to engineer and install the unit myself in a spare rear end and torque tube. Not for the weak hearted but highly recommended. Anyone with questions or wanting to tackle this themselves, I would share advise/knowledge from my experience. I am still in search of a spare o/d housing R10B-1G or R10B-1R if anyone knows of one.
  6. Still searching for a good R10B-1G or R10B-1R overdrive housing or whole unit. Probably attached to a T86 transmission 1940's Nash, Rambler, Studebaker, etc.
  7. R10B-1R or R10B-1G housing needed probably out of a 41ish Studebaker or Nash Rambler or off of a T86 tranny
  8. Thanks, I will call him Monday. I used his wiring diagram and love it!
  9. R10B-1R or R10B-1G I need a housing but a complete unit will work A shop in Washington State cracked my housing at the shift pin. We welded it but it's dripping. Need another. Please help