Handyman57

Headed to the exast shop to get some pipes,I installed cast iron dual headers from Tom Landon stove bolt headers out of Michigan, he builds them for the old flathead and early 6 cyl. Chevy. Wanted to upload a video of how they sound,but wasn't allowed to large I guess. But I'm very happy with the install and the end results Thanks T

I have noticed that the oil pressure will fluctuate between 40 to 20 lbs even when holding the throttle a steady 800 rpms,or higher, is this normal, or is the pressure relief got a problem? Thanks T

anyone have a pic of the tool /gage used for ajusting these brakes,or tips on ajusting them without one Thanks T

Thanks,your right that was the body no. I found the vin no. On the pass door henge post Thank you T

My vin # for my 41 Chrysler royal coupe is C28cr-3854 346-766 - P1. T3 Job No. 11-20

Here's the arbor

Hi guys,I need to replace the wippers on my 41 Chrysler royal coupe to, anybody were to get aftermarket ones,I need the arms to. Here's a pic

Hi guys,girls I'm looking for pic ofthe dash of a 41chryler royal dash,looking to locate the heater sw and what it looks like, mine is missing Thanks

Hi guys,just an update on my 41 royal,its been siting for 20 years,got it running,had to clean the gas tank and install a new coil (not stock),it needs a carb kit (know where to get one?)working on the brakes,bleeders are frozen . Thanks handyman57

Hi guys,i have a 41 chrysler royal coupe,at present the gas line is run down the drivers side on the outside of the frame,is this stock location? I have always seen the line on the inside of the frame. Thanks

Handyman57 Hey do guys know what the little toggel switch under the dash on the driverside of my chysler royal coupe is for Thanks

Would the repair pieces have to be from parts cars or fabricated steel?

Hi guys,I'm new to this site,here's my question,i have a 41 chryler royal business coupe,the car has rusted out floor pan along door sills&other places,would this car ever meet juding qualcations after repairs?