panelbeater1234

Looking for a carburetor for a 1929 Nash standard sedan or were i could purchases Regards John l

looking for a 1929 Nash standard 6 carburetor Regards John

I have a 1937 dodge police car and have run the piping around the top section of the fender and ready to attach the inner metal panels and the black piping goes between No other clips to go around ??? .a photo would be great .Cheers john Schicker

have purchased some front of the rear springs where a bolt goes through

would like to obtain 4 new rubber bushes Need your help .Regards John 1937 plymouth p7

Many thanks for for your help went on that site it was numberM123 never been on that web page they Shure have a lot of good stuff yes i purchased the rubber from Steel rubber products that was 3 different types and fit 100% until next time many thanks .......John Schicker

Would someone put me onto some wone that can supply please as you know fits to the inside metal garnish of the doors....john its the inside glass sweeper where can i purchess from regards John

Would someone put me onto some wone that can supply please as you know fits to the inside metal garnish of the doors....john

Having trouble to work out weather to remove the windup mek or leave it in place its getting it to run in its slide in positions have urethane the steel groove to the glass as all that is permanently set in place this is for my 1937 dodge d5 model very frustrating i can tell you Regards John

would like to see a photo of the dodge .....john

Hi there i have 7 very rusty but they would be easer to make from stainless steal ......regards john

Would someone be able to help me to locate the part ie rubber or felt that when the screen is wound in it stops water entering inside i have the new rubber that fits around the frame and when the screen is closed it seals against the body of the vehicle Kind regards John

Would like to find out what material and where to purchases from as i have a 1937 D5 dodge On the metal that holds the glass i have the rubber that fits around the outside edge and seals around the opening of the body when wound in .But looking for the molding that goes between the glass and metal frame and as it is wound back in towards the body of the vehicle .Looking forward to a reply regards John from new zealand

what were you wonting for the part .Regards John

Would like to purchess 4 door springs for a 1937dodge sedan small one end and larger other .Regards John

Hi john here would you sell it to me .Cheers john

Would you have a pattern for one regards john

Hi would someone be able to help me to find a Power transformer for a ford F_1540 Radio for a 1938 ford coupe

Hs any one ot there have any parts for a Montgomery terrier 125 cc or restoring one Regards John

Would some one have a radio panel that that fits in the dash of a 1938 dodge as per photo

Would some one have one also could someone make one .looking forward to some one helping me regards john

i have plymouth gauges in the 37 dash and assume the moldings will fit along the bottom edge of the bonnet that way i never got a reply .....thanks for replying ....john

These run along sides of bonnet stainless steel

Still would like to purchess two moldings along both sides of the bonnet