Jump to content

rickoshay

Members
  • Posts

    10
  • Joined

  • Last visited

About rickoshay

  • Birthday 06/04/1948

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

rickoshay's Achievements

  • Collaborator

Recent Badges

10

Reputation

  1. Hello All Does anyone have a good number for the axle seals on a 1950 GMC 1/2 ton, model 100...? regards RichG
  2. Anyone know what's involved in replacing it? thanks richg
  3. I have a 1950 GMC 100, the gear oil from the trans seems to be leaking into the differential. Does anyone know how to fix this? RichG
  4. Hello Does anyone have experience with adjusting the hood latches on these older Buicks? I have followed the shop manual instructions over and over but the hood still will not close correctly. Either the front or the back closes but not both....any help here? rg
  5. I am in the process of repairing the wiring of a 1951 Buick. Does anyone know where to obtain the "bullet" terminal wire ends, used at the fuse panel? They measure approx. .220" diameter. rg
  6. I need several items including rear window interior frames, trunk lock assembly, a cigar lighter and an ignition switch assembly. Seven Two Four Seven One Nine Six Zero Six Five.
  7. Hello Does anyone know of a 1951 Special that is being parted out. I need several items including rear window interior frames, trunk lock assembly, a cigar lighter and an ignition switch assembly. regards to all Rich G
  8. Does any know how to replace the weather stripping above the side window on a 52 Desoto two door hardtop (Sportsman). I have the correct material but don't know where to begin. I certainly appreciate any of your help on this.
  9. Thanks for your reply, I have had the choke housing apart and it is clean. Just no heat comin gup the tube....I will try opening it up.....
  10. This is my first post, thanks in advance for helping me. I have a 52 Desoto with the 264 hemi and I cannot get any heat up to the choke housing. I have replaced the heat riser and it is working correctly. My question is; should that little 1/4" tube be open all the way into the exhaust manifold...should I just blow it out with compressed air......anyone experienced this problem?
×
×
  • Create New...