37 Buick Special

Members
  • Content Count

    86
  • Joined

  • Last visited

Posts posted by 37 Buick Special


  1. Thank you Matt, Dave and Carl. It is not clear to me regarding your explanation of the issue with my manifold. When you say they cut the studs off. Here are a couple of photos to make the starter switch a little clearer. It seems to be the same as your manifold Carl if I am looking at the right place. Agreed, if need be I would go for a manifold replacement. You are saying that I could not replace the Cold Idle Control Thermostat with a correct one with this manifold?

    Thank you,

    Dave

     

    Starter Swithc 3.jpg

    Starter Switche 1.jpg


  2. Would anyone have images of their 37 motor with a Stromberg carburator attached? Specifically I am looking for the left side of the carb. I had mine rebuilt and now have an issue or two. Things aren't lining up. The Adjust Stop Screw does not line up with the the Cold Idle Control Cam. The cam is a bit loose and there is a washer behind it but I believe it has to be loose.

    Thank you for any pointers.

    Dave

    Carb.jpg

    Carb1.jpg


  3. Gary,

    Sorry to hear of your carb issue. Amazing to find an NOS carburetor. I would agree with Matthew. Too long for a carb to site unused. I have sent a number of carburetors (Chevrolet, Ford and Buick) out for rebuilt to a business in Florida. They come back just super. You may have heard of them. Daytona Auto Parts. I would highly recommend them if you need a rebuild. Good turnaround time as well. https://daytonaparts.com/

    Best,

    Dave

    • Thanks 1

  4. Carl,

    Thank you very much for the clear photo. I did find an original manual in the trunk. As you see from the photo the two wires come out of a loom and are so old there are no markings on them. The connectors are different though. That was the reason for my question. So I can't tell which wire goes on which side of the switch. One connector is towards the bottom of the photo and the other to the right of the masking tape. Thanks for all your help.

    Dave

    Starter Switch.jpg


  5. Gary,

    I can't tell of which connectors is which at the end of the wires where they connect to the switch. The photos are a bit blurry. Could you by chance take some more (and advise of the connectors) and of the outboard side of the carburetor. After I sent the carb out for a rebuild two things don't line up. The threaded adjustment screw (don't tech name of these parts) and the butterfly like piece with the slot in it. There is a washer behind it that could be removed but that still would not be enough to compensate fof the offset.

    Thank you for your help,

    Dave

    carb linkage.jpg