Jump to content

Mun24ster

Members
  • Content Count

    5
  • Joined

  • Last visited

Community Reputation

10 Good

About Mun24ster

  • Rank
    Junior Member
  • Birthday 02/24/1959

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. So I checked the wiring behind the key starter. The screw in the back runs and is connected to the coil. The remaining 2 screws on the side of key starter have various wires going out. So I made up 2 wires and placed them on the screws. leaving all other wires attached. I ran the 2 wires and joined them to the screws on the push button starter. The wires from the push button starter lead to, 1 wire goes to the coil, and other wire connects to starter solenoid. Still am not getting power to the push button starter, am missing something somewhere. I do have the 40 Buick manual with the wiring di
  2. There is power in everything under the hood in my switch to 12 volts in my 40 Buick. The problem is no power getting to the push button start from the key when I turn it on. There is no wire going from the key to the push button start. I am wondering where to run a wire from back of key switch to starter button. Not worried about gauges right now, besides they all don't work anyway. Just want to get the car running. Thanks.
  3. I am currently switching my 40 Buick to 12 volts. I have removed the generator and put in an alternator with a self contained voltage regulator, thus eliminating the car's original. I put in the required ignition coil. Also replaced the starter solenoid. Of course replaced the battery to a 12 volt. Made all the wiring changes according to the info sent to me by vintage auto garage, where I purchased the kit. My 40 Buick method of starting the vehicle has been switched to a push button start. Now is where I am stuck. When I push the button, I am getting a clicking sound as if its trying to send
×
×
  • Create New...