I don’t know if this will help but I had same problem ,i made my own gaskets for cylinder head mounts
and my gasket paper was too thick,this put the spout tighter on one side causing a small leak
thinner gaskets solved my leak!
I need help with the rear glass fuzzies,the ones I purchased have no fuzz only the rubber wiper,can someone tell me if someone
sells those inside fuzzies to the glass?
Thanks for any assistance
Gordon Purves
Have the piece I need but want to sell complete power antenna,with broken mast , riviera bob came
along with the correct piece,
thanks for help Gordon Purves.
Want to buy antenna bezel and the clip that holds it for a 1965 Buick riviera, I have working antenna no fender mount?
Thanks Gordon Purves Nova Scotia Canada.
I tried to use a rubber tube but too tight,I will try the used parts dealers ,I found it in the manual finally,no an easy spot to work
thanks again for reply
Gordon Purves aka gord14080
I am installing The ac defuser the plastic piece that directs air to drivers side and Center vent ,what is the connection to the evaporator box ?
plastic to metal doesn’t fit inside or outside,is there apiece that goes around this connection or how do I make this tight?
Any help would be appreciated, sorry I am working on 65 riviera.
thanks for any advice!
Gordon Purves aka Gord 14080
thanks again.
Small emblems?
when this man talked about small emblems he said they moved to the bigger emblem in the middle of December,
my car has small emblems and build date is last week December 64, question is ,can this be possible or does anyone
know the change over for sure? I was surprised by those comments .
thanks Gord Purves 14080
It seems to be a common problem with this broken.guide,can they be welded,and if so what gas and rod type? Anyone i
asked said it cannot be done need some advice from someone who has experience?
thanks for any advise,
Gordon Purves thanks gord14080
Telriv,that was my concern,yes I think I shall do something to close that tube like you did .
thanks for the reply, I thought I may have lost.something from the bottom of the column.
Thanks again,Gordon Purves.
I don’t have anything to keep the shaft centered ,seems I am missing something,some sort of bearing?
yes I have manuals,but cannot find good description.