sherwood3333

can any one tell where I can get window fastener clips for the outside window trim, it appears to a long threaded shaft that has round threaded cap to hold it in place thanks

thanks, how do you get old seal out?

just picked up my rebuilt motor and trans, next will put the two together and install back into wagon, went back to desert valley wreaking and found more of the parts I needed30 ac of old cars

looking for glove box door, one piece , no padding thanks

thanks old tank, shop only had transmission

got my trans back today, shop person said I need to replace seal on drive shaft end so trans fluid will not drain back into rear end, can any one tell me what seal I need to order and were to get one thanks

thanks jim pictures helped sherwood

can anyone tell me if the upper garnish that goes on above the windows that runs from the front to the back of the rear window is the same on a 4door as on a wagon, im looking for this garnish for my wagon thanks sherwood

thanks , that helps!!!

ok thanks

looking for a chrome or painted glove box cover , I have a padded one but I want to go with soled metal also still looking for tail gate bottom latch handle

front and rear suspension , also new breaks all around, in and ready to roll, also working on rear seat and cargo area.

can anyone tell me or show pitchers of the center handle-latch assembly so I can tell people what iam looking for , I need parts for my tail gate, cant fine diagram anywhere thanks

can anyone tell how to remove rear shocks on a 57 buick, up at the top of the shock there's some kind of bracket holding the shock bolt but I cant seen to figure out how to get shock out

went to desert valley wreaking in casa Grande az. scored rear cargo area garnish trim that I was looking for , engine bay all cleaned up and ready for new shoes and springs, trans and motor should be back in about 2wks or so, working on the rear section next

ok thanks

can anyone tell if any one makes a replacement gas tank for a 57, or a used one, or the dimensions so I can something that will work , thanks sherwood

motor and trans pulled out of car today, quite a job don't think this has been done in quite some time!!!

do I need to anything to the rear end or just leave it in place

getting ready to pull motor and trans, can anyone tell me the best way to do this? I have dog house off the car, thanks

Buick Man, thanks this is what I needed!!!!! I do better with pictures, now I know what the inside looks like when finished

can anyone tell me the demission's of a gas tank for a 57 buick?

motor being taken apart , heads off, block next

does anyone have pictures of the inside of a 57 wagon?

looking for 57 wagon interior parts