NeilO
Members-
Posts
39 -
Joined
-
Last visited
Content Type
Forums
Gallery
Events
Everything posted by NeilO
-
Try Futureline Auto & Marine Upholstery in Exton Pa. 610 363-7977 Neil
-
When I was dealing with them I talked most of the time to Dotte. As I have said in the other topic about this business, I can not get any satisfaction from them. Neil
-
-
Authentic vintage Lincoln Zephyr battery sought
NeilO replied to West Peterson's topic in General Discussion
Be careful I sent them a defective battery back to them in Jan. Called them in early March . They said it would be sent out to me later that week. I called back two weeks later and was told it must have gotten lost in transit. I was told another would be sent, Still waiting. No one answers the phone or returns calls. Neil -
Sorry. it was Jim`s Battery. not BCM, I will go to BCM for my next battery. Neil
-
Took me for $375.00
-
If you became a member of CTCI, you can receive information on your 56 Thunderbird. CTCI Classic Thunderbird Club International Neil
-
Yes it is manually and is locked and unlocked by the turn of the column. Neil
-
Hi, The steering wheel can moved in and out several inches. Neil
-
Yes I was , it was much higher then what I was getting when I tested for It. I am thinking of just biting the bullet and buying a new one Neil
-
I have not worked on it lately. I don't know what to do next. Have tried everything. Neil
-
The car is 6 volt Pos. The wire is not in any position to be pinched. Gage is hooked correctly. I rechecked the ohms. When the float is down it reads 12. When the float is raised the numbers decrease. I am not sure what the numbers should be, but they do not seem correct to me. I need to find what they should be. Thanks for all your help so far. Neil
-
Did all of the above
-
The tank has 10 gal. in it. When I can get the gauge to read outside the tank, it reads correct. Neil
-
Auburnseeker, The float is brass and floats. No extra play in the arm. Neil
-
Hi auburnseeker, Thanks for your response. When I test it outside the tank I hold it as it would be in the tank. I can ground it to the tank or the trunk floor and it will work. If I install it in the tank it does not work even if I ground it to the same two places. The unit worked ok in the old tank. I do not want take it apart if I don"t need to. Neil
-
I have a 55 Thunderbird 6 volt. I replaced the fuel tank and now the fuel gauge does not register. I have done all the tests and from the results it shows the problem is the sending unit. If I take the unit out of the tank and ground it. it will work. If I put it back in the tank It will not work even if I ground with a wire.?????????Thanks in advance.
-
Kickin Cancer Cars and Coffee Event at New HQ
NeilO replied to paul455's topic in AACA - Shows and Tours
Is there trailer parking at the show? -
I was there also great cje. Neil
-
1954 Ford Belt Molding Clip WANTED
NeilO replied to oldford's topic in Ford, Edsel & Mercury - 1954 and Newer
Hi Oldford, Try T-Bird Products in Exton Pa. Neil -
I am looking for a oil dipstick for a 1955 Ford 272 engine. Thanks in advance. Neil
-
-
1957 Ford Upholstery Question
NeilO replied to Paul Dobbin's topic in Ford, Edsel & Mercury - 1954 and Newer
TRY L eBARON Bonny -
Well I checked the fuel pump and the carb and they are both working fine. I also checked the valve springs and they are ok. The vacuum advance and yes it is working. Help Thanks Neil