Jump to content


  • Posts

  • Joined

  • Last visited

About NeilO

  • Birthday 08/19/1946

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

NeilO's Achievements

  • Collaborator

Recent Badges



  1. Yes it is manually and is locked and unlocked by the turn of the column. Neil
  2. Hi, The steering wheel can moved in and out several inches. Neil
  3. Yes I was , it was much higher then what I was getting when I tested for It. I am thinking of just biting the bullet and buying a new one Neil
  4. I have not worked on it lately. I don't know what to do next. Have tried everything. Neil
  5. The car is 6 volt Pos. The wire is not in any position to be pinched. Gage is hooked correctly. I rechecked the ohms. When the float is down it reads 12. When the float is raised the numbers decrease. I am not sure what the numbers should be, but they do not seem correct to me. I need to find what they should be. Thanks for all your help so far. Neil
  6. The tank has 10 gal. in it. When I can get the gauge to read outside the tank, it reads correct. Neil
  7. Auburnseeker, The float is brass and floats. No extra play in the arm. Neil
  8. Hi auburnseeker, Thanks for your response. When I test it outside the tank I hold it as it would be in the tank. I can ground it to the tank or the trunk floor and it will work. If I install it in the tank it does not work even if I ground it to the same two places. The unit worked ok in the old tank. I do not want take it apart if I don"t need to. Neil
  9. I have a 55 Thunderbird 6 volt. I replaced the fuel tank and now the fuel gauge does not register. I have done all the tests and from the results it shows the problem is the sending unit. If I take the unit out of the tank and ground it. it will work. If I put it back in the tank It will not work even if I ground with a wire.?????????Thanks in advance.
  10. I was there also great cje. Neil
  11. Hi Oldford, Try T-Bird Products in Exton Pa. Neil
  12. I am looking for a oil dipstick for a 1955 Ford 272 engine. Thanks in advance. Neil
  • Create New...