Jump to content

LOOKER

Members
  • Content Count

    2
  • Joined

  • Last visited

About LOOKER

  • Rank
    Junior Member
  • Birthday 08/21/1973
  1. Thanks !!!!! However, bearing/thrust clearances are not my issue... I need the minimum-maximum Crankshaft Specs that I might find in an OLD Clevite book.. I also still need the housing bore spec for the big end of my rods, as well as the mains. I have a FoMoCo shop manual for this engine already... Thanks, justin.
  2. Does anyone out there have crank tolerances (miniumum & maximum) for the 1940 292 CU. IN. V-12 flathead engine..?? I also need the 'housing bore' specs for the big end of the rods. Would greatly appreciate the help. Justin
×
×
  • Create New...