aussiesteve

Members
  • Content Count

    6
  • Joined

  • Last visited

Community Reputation

10 Good

About aussiesteve

  • Rank
    Junior Member
  • Birthday 07/13/1960
  1. Hi guys hope you can help i have a 1930 66 chrysler i am looking for the pipe and fittings that join the oil pump to the block . I think they are 7/16 pipe and fittings thank you hope you can help Steve
  2. Thanks mate have a great day Steve
  3. I have a 1930 66 coupe it is an Australian built car , I am chasing a complete gasket kit for it . the distributor goes down the centre of the motor I have 2 old head gaskets the numbers on these are [1164 ] and [708 ] I have emailed Egge Machine co and they do not know these numbers . have a great day Steve
  4. Hi, hopefully someone can help me. I am rebuilding my 1930 Chrysler 66 engine it has 3 1/8 bore. I would like to know when all main bearing caps are tensioned down without the bearings what should the inside measurement be so when it's line bored, we can get all the caps to pull down evenly. Any help will be greatly appreciated. Steve
  5. Hi dudley I found it easyer to steel my coupe out then redo all the timber .I also did steel the roof out and the 19 in wheels look very good .
  6. Hi everyone, I'm from Australia and this is my first thread. I have a 1930 66 coupe and am having trouble over here with babet bearings. Is there anyone over there putting insert bearings in their motors? Have a great day. Steve