Alfre

I take it you don't have the springs? Al

I've been there horse is on the menu Al

The above is good advice. The distance from eye to eye would not be correct this measurement would have to be the total length of the spring leaf along the bottom to the center of the eyes plus the material to make the eyes. Al

Bad ground

it is one

This mag has a manual advance on the stearing wheal and must be retarded when started. Al

Check the intake and exhaust valve gap, when warm. Al

looks good Al

As I have 3 gardner cars and some parts for 4cyl and 8 cyl I will look for the parts you are looking for. It might be a little while as the temp here was -6f this morning and a high of +16 and 1 and a half inches of snow and a forecast of another foot or more tonight. Al

I do these parts all the time just blow out and wash out with thinner not water. Al

The liner is needed when mounting on wire spoke or split center rims as they can rune the tube. Al

seal all will last years if properly applied Al

Seal all is a name brand and is applied externally and comes in a tube like plastic glue. It will seal with gas in the tank and leaking. Al

USA cars are still exempt AL

Go to a auto parts store and get a tube of seal all it will seal gas tank leaks. I have used it numerous times on my 73 gmc as there tanks had rust issues. Al

With the new curtains should get senior with no problem. Al

John I know you had the curtains at Hershey, but I did not notice the fittings for them on the car if there is no sign of of fittings ,curtains are not required. So far we have only had 16 inches of snow that has melted but a good chance of a white Thanksgiving,at least we did not get the 5 foot that those West of us got. North of us by 15 miles they got 4 foot. Al

Remove the oil pressure sensor and plum in a gauge. the oil sensor is located near the fuel pump in the center of the engine by the oil filter often the wire is loose and gives a false reading. Al

A screen door spring can be made into one. Al

The alternator wire goes to the battery wire and your amp gauge should work. Al

congratulation on the first junior and good luck finding a Morris woody. Al

How did you did place? Al

Did you check the end of the push rods, as they ware and go out of round and don't fit the new rockers, also if the push rods did not return too the same place as removed this can happen. Al

John, good luck on pushing valve stem in, should work. I will be watching for you and the car on Saturday btw I was a senior master judge for meany years on early autos especially steam powered. Al

Is the antenna trimmer properly adjusted? Al