Alfre
-
Posts
234 -
Joined
-
Last visited
Content Type
Forums
Gallery
Events
Posts posted by Alfre
-
-
water pump plyers
-
1
-
-
You need a chain breaker to take it apart. to assemble it a small nut that fits over the pin and a c clamp to assemble it
-
contact a amature radio operator in your aeria they can usually help
Al
-
the knob is a seat adjuster
Al
-
1
-
-
The reason we never bought lite duty IH is they road worse then the heavy duty ones in our well drilling business .
Al
-
1
-
-
catsup squeeze bottle
-
1
-
-
the brake cylinder on the buster is probably stuck.
Al
-
those are 30 bumpers with that madlion ,29 are cast with points on each end they are very close to 29 in shape and size.
-
Merry Christmas John from the snowy North.
AL & Mary Ann
-
clean the points even if they look good
-
John
you can get a new at tractor supply fits allis chamber b,c
Al
-
When down shifting one must depress the clutch place shift lever in neutral release the clutch rev the engine too approximately the correct rpm for low gear for the equal road speed depress clutch and then shift into low .
Al
-
2
-
-
I agree with window cleaner works great
Al
-
The oil sensor is known to fail
Al
-
Check the battery terminals,
there is a good chance where the wire goes into the clamp it is very crowded inside.
To check pull hard on terminal, it may come of.
-
I believe the start terminal should be labeled accessory and the gas gauge would go there the rest would be correct.
Al
-
Stopped raining ,I found cap,
It would be easier to contact me at dadgerisch@gmail.com.
Al
-
If it stops raining I will look for it. I drive a 29 coupe on some vcca tours
Al
-
Do you need the fill pipe and cap or just the cap? I may have a cap.
Al
-
You are getting air into the cooling system either at the water pump or leaky head gasket.
Al
-
1
-
-
I don't have a photo but you are looking for a pipe that is threaded on one end and crimped almost closed on the other also a spring that fits inside the pipe and a rod that goes inside the spring that has an large flat washer that will not go through the spring and has a ball end on the other end that hooks into mount on car frame.
-
top part of a hood latch you are missing the barrel ,spring,and center rod that attaches to the car.
Al
-
1
-
-
Good job putting the tractor back together , can you use your two post lift to position the wheel?
Al
-
Warm up engine lock brakes and yank shift into high gear with engine idling do not use a lower gear, should stall engine if clutch does not release.
Al
-
1
-
34B oil pressure
in Marmon
Posted
Are you sure the line going to the gauge is not pluged
Al