Jump to content

broker-len

Members
  • Posts

    2,059
  • Joined

  • Last visited

Everything posted by broker-len

  1. have to differentials think PA or 30U they should be the same
  2. still looking for a PA Plymouth manifold
  3. I have owned this car for 40 years put some grease in the rear wheel bearings one time but that is it the seals that were in there were pinion seals and worn out the seals from andy were were made in India the holes seem to be stamped out and I had to file them to get on axle the rubber seal is a bit lose in the metal cage but since I can not fine them any where else I am using them to replace the inner seal have to pull the axle and bearings not going to do that pumped grease into the fitting 3 or 4 pumps till grease start to ooze out of outer bearing put the drum on then two more pumps send pic of seal later
  4. have a few good pairs of rear seals for Plymouth 36 to 42 contact at bobnroman@yahoo.com
  5. in case andys seal is not right got two other part numbers that may work Victor 49751 and fel pro 2520 any one have either one of these seals thanks bobnroman@yahoo.com
  6. I saw that I have heard mixed reports about burnbaum but the picture on web sight is just what is in parts book so I ordered it wish they would have given a part number !! will let you know-----------bobnroman@yahoo.com
  7. the parts lists 43053 the seal from car 11506 SUPER see picture looking for this or replacement seals bobnroman@yahoo.com
  8. Thank you for sharing your thoughts I will check again but as I remember this pipe is bigger than my PA
  9. that is a PB manifold again the sleeve is in what I think is a NOS pipe trying to find out if this came from the factory
  10. broker-len

    PB Exhaust

    Picture shows what I believe is NOS Plymouth 32 PB pipe and manifold do not believe the pipe to ever be on a car is the extension on flange as it was from factory looks like it fits inside manifold but will not go----------------thanks for your help bobnroman@yahoo.com
×
×
  • Create New...