keen25
-
Posts
84 -
Joined
-
Last visited
Content Type
Forums
Gallery
Events
Posts posted by keen25
-
-
Hi Keiser31, thank you for your reply, what are you asking for the rings?
-
-
-
-
-
NC Industries .
- 1
-
Hi I need one rumble seat step chrome ring for a 1933 or 1934 from a Plymouth or Dodge, maybe others. If you have one for sell Please call 856-697-5361 or akeen1925@yahoo.com, thank you Erick
-
Hi 33 Dodge DP,
My father has 1933 Plymouths and the head you are looking for it was NOS when head got it in the 1980's which he put on his 1933 PD.
He is located in Vineland NJ and if you want to talk with him please tell me. Thank you, Erick
-
Hi Chris,
I am going to most likely get a close rubber channel from McMaster-carr. I will try an see If window bedding tape works and also use a piece of vacuum hose. The Grill has rubber bumper which are attached with split rivets so they will come off very easy. Erick
-
Chris, I wonder if the window parts where Galvanized, the ones I have look silver? I most likely will paint them. Erick
-
-
-
Thanks Selmer.
Erick can you post a few more pictures of the rubber part?
I will, what area would you like to see? I can make a sketch with dimensions, I will need to for a replace piece.
Erick
-
Tom, I don't think that is for the trunk area of the car (I have never seen one there) but I think it is for a later maybe 35 grill? Erick
-
Hi Chris,
I don't know about Kanter's but they have been around for a long time. The engine in my car was rebuilt and runs great so did not mess with it. I have attached some pictures of a block which I pulled a pump from, there is a lot of surface area for adhesive. This block was rebuilt about 2003 and the pump still a very painful task to remove, I broke a stud. I would use a good amount of heat and take your time.
-
-
Send picture of what you need, I'll probably havpiecemealpiecemeal
I think the PD is a 1933 model?
-
-
-
-
A few pages back the question of the placement of the holes for the rear tail lights was asked, that question just hit me also. The '33 PD Convertible with rumble seat I am working on had originally only one tail light and during the car's life someone welded in a patch to install an odd set of tail lights. I wonder is the location the same as the sedan, I have attached pictures of ones I have. thank you Erick
-
Hi Scott and Chris Thank you, once I was given the clue what to look for it became very clear how the stainless steel is on the frame, thank you, Erick
I am posting my progress on the window frame, I am putting in new glass soon. I tried to show some of the rubber part that are in the channel - the two little ones that hold in the draw rod are interesting.
-
Hi Scott and Chris Thank you, once I was given the clue what to look for it became very clear how the stainless steel is on the frame, thank you, Erick
-
I would like to know if the window frames on the 1933 PD convertible are stainless steel or chrome plated? thank you Erick
Step Ring
in Parts Wanted
Posted
Hi Keiser31, I would like to buy the one in the center or #2 down from the top. I can pay with paypal if you want. I am in NJ 08360