rtjavelin

I need some help on how to remove the glass from the frame of my 37 Dodge d-5. I don't want to screw this up thanks Rob

Hi John I need a set for my 37 dodge d5 coupe .how would you like to receive payment, plus shipping costs. I live in Vesper , Wisconsin, 54489 thanks Rob

No I'm too far into anything to go back to 6 volts I might give it a try

re- wiring my 37 dodge, upgrading to 12 volts. the question I have is can I run a negative ground on this car with the original starter? I have done this with n old allis chalmers tractor, but It appears that I have a direct short due to the starter. I did an up grade to a 12 volt starter solenoid and voltage regulator and alternator. Will I need a new starter? if so where can I find one . Thanks

thank you much. appreciate it RT

Need a little help , just started working on a 37 dodge D-5, does anybody know if it is a positive or negative ground?

Looking for trim that fits on the shell, that goes around the grill, doesn't have to be great. thanks RT

Thanks guys, that's a great help. I am going to rebuild it thanks RT

I need help on the year of engine in a 37 dodge, the head casting number is 1618823-9 and the engine I.D. number is P26245075. I would appreaciate any help I can get. Thanks RT

Has anyone put an old school dodge v8 in a 37 dodge coupe, small block or an RB block. The reason I am asking is I have never converted an old coupe to a v8. Just asking to see what unforeseeable problems I am going to run into, like cutting the fire out, can I use the original steering column? If ya have any suggestions I would like to hear from you. I plan on using a auto trans with a dana 20 rear axel. thanks RT

Say I am new to the old coup world and need a little help. I want to put an old school dodge motor in this dodge, like a 340 small block or an rb block and wondering what's a good choice as what will clear the original steering column, or do I need to replace it and do I need to cut away the fire wall to fit an automatic tranny. It appears that there is room for a big block dodge but I don't want any surprises. If anybody has done one of these cars I would greatly appreciate it thanks rt

Say I was wondering if anybody could help I'm considering restoring a 1970 plymouth road runner. I never fooledd around with plymouths before and I would like to know what parts are impossible to get and whats available for them, where to get some good lierture on serial numbers and codes, and a couple of good clubs to join. If you can help I sure would appreciate it thanks rtjavelin:)