Jump to content

pre1939chrysler

Members
  • Posts

    490
  • Joined

  • Last visited

Everything posted by pre1939chrysler

  1. No, they didn't. Run your car with 30-wt oil for a while and most of the advice you were given. I have the same problem but just have to work with the felt or leather and it will stop. Just take oil with you on trips. You won't loose too much. Another crank would help and I have a few bur I;ll put up with the leaks ,.
  2. I'd be careful on that . Some years back Narve and I ran into a problem with a model 65 I sold him. Apparently WPC used a 4 cylinder chasis on the larger roadsters.Narve correct me if I' m incorrect. J
  3. I may have a couple of 29 Chryslers and yes that was the last one for the one picture, I also have others for model 65 which is slightly different. I'll look tomorrow. i know a few guys use the later top-bolted master cylinder but it didn't use the resistor and wasn't as effective. My master on my 29 /75 has worked great since I rebuilt it 25 years ago.
  4. This water pump has a passenger-side water outlet. A good core or complete is acceptable. Send the price and pictures if possible. astheime@ptd.net 610 863 6955 Jay
  5. 18" diameter $200. plus postage, contact me for measurements and available parts. 610 863 6955
  6. Hello gentlemen, I have many fedco plates off early Chryslers and never gave it much attention. Many I have removed from bad dashes ND could take them apart without much trouble . I always start from the back and work foward My 29 Chrysler I have and since I was 13, had a copper color but the silver may have come off I don't think Chryselr would paint any part of the plate.Personally I would not try to remove the plate but plate it it in place. A WIRE BRUSH CAN BRING OUT YHE HIGH LIGHTS.
  7. Good luck , model 75 you can find but the 72 is impossible. I have complete tail@light lenses in the taill light drum but will not seperate.
  8. yes , otherwise I need measurements of your steering tube and what you have at your column
  9. I have exactly the one you are looking for in fantastic condition. I will post pictures or contact astheime@ptd.net and I will send. Jay
  10. These are what I have or will have soon. astheime@ptd.net 610 863 6955
  11. As we write I have distributor hausings being cast. I should be getting them any Day now. If you send me a few pictures of yours I might have one They had about 3 different ones. Astheime@ ptd.net As 610 863 6655
  12. When finished , be sure too add an acid reducing/ lubricant to the water/ anti freeze , organic.
  13. I had the double wing nuts and Bolts and didn't realize I had sold all of then or would have made them.
  14. They are and my foundry is slow but very dependable. I just won't have them machined for the wing nuts. Now I owe you.
  15. Actually, I just picked up a beautiful steering wheel,with all the levers, horn button and tubes. It is off a 1927-8 model 70. ALL $500. I think the wheel is 18 inches. I ALSO PICKED UP A great gas tank Ns a pair of round shocks with brackets. Starter too. Astheime@ptd.net Leaving for hunting camp soon.
  16. I love to get some more made but I would have to find someone who would lown me a pair. J
  17. The72 didn't have wood it was all bakelite . Leo was over and showed me the correct one. Will send picture Mondaty
×
×
  • Create New...