25343 Members
87 Forums
114849 Topics
509378 Posts
Max Online: 479 @ 03/26/08 04:18 PM
|
|
|
Lost your password? Can't remember your username? Having registration problems? Answers to many of these problems can be
FOUND HERE!
|
|
|
#500655 - 04/08/08 12:41 PM
Heater Core and Water Pump
|
desperate1
New Member
Registered: 04/03/08
Posts: 9
|
New to classics. I have a '61 LeSabre with a 364 V8 with a leaking Heater Core and it is overheating. Can I bypass the Core by connecting a hose from the inlet and outlet tubes of waterpump only, without having heater core hoses attached? Will this cause any problems?
|
|
Top
|
|
|
|
|
#500687 - 04/08/08 02:55 PM
Re: Heater Core and Water Pump
[Re: desperate1]
|
simplyconnected
Member
Registered: 11/06/07
Posts: 189
Loc: Detroit (Royal Oak), Michigan
|
In most applications, they block both hoses (like the heater valve does). But, I'm more concerned about your overheating problem.
Your '61 LeSabre is a great car. My uncle had a wagon, new. We took a big family trip over the Rockies, and the Buick had to stop periodically because of heat issues. (Our car didn't). That was in '61. Certainly, those Buicks ran just fine with 'regular' driving, but I'm not surprised you are having problems today.
I don't have answers for you regarding system capacity, etc. Lack of flow is always the cause of overheating.
Believe it or not, a big air pocket will cause overheating as well. It's still lack of flow. At the factory, they vacuum the system, then fill, for two reasons. If the vac leaks, there's no sense in filling, and, once all the air is out fluid fills all the voids.
If you rad is restricted, a radiator shop can do a flow check. Thermostat sticking closed is another cause. If the pump and hoses are flowing properly, you may want to do a high pressure block flush to clear out piles of rust that settled around the cylinders, etc. Beyond that means pulling the heads and/or block to get inside freeze plugs and clean all the passages using a wire to dislodge rust. Freeze plugs would then be replaced, and new head gasket holes are already clear.
A MAJOR recent problem, is when old type anti-freeze is mixed with the new 100,000 mile coolant. They are NOT compatible, and when mixed, turn to mud that is real hard to pump.
Collectively speaking, spending more money on products doesn't mean you're doing your car a favor. Mixing incompatible fluids in the rad, brakes, and crankcase is common with too many home mechanics.
I hope this helps. It would be a treat to see your Buick on the road again.
|
|
Top
|
|
|
|
Moderator: BUICK RACER, R W Burgess, 24T42, Peter J.Heizmann, Steve Moskowitz, Brenda Shore, gagliaj
|
