Yes, we're trying to get someone to make a run of club badges, make that license plate medallions, in cloisonne. We have the design set up, basically. Our local guy is giving us a hard time.

We'd like the 3" jobs with a license plate tab.

Any suggestions?

Wayne

I guess I don't know what a 3" job with a licence plate tab is? But, you can get anything you want from the outfit that brings a display to Philadelphia. I can't remember the name but Mr. Jones, or the man who does the vender setup at the Annual Convention would know. They are in New England.

Wayne, call me.

One suggestion are the vendors that work with fraternal organizations like the Elks or Knights of Columbus. They make very nice pins in exquisite detail in Cloisonne Enamel and other finishes using your artwork for about $1.25 each (qty=250). They tend to make their products small, 1.25 inches. Perhaps they can make them larger, 1.5, 2 or 3 inches since all orders are on a custom order basis and maybe they can offer it with a machine screw instead of a pin and clasp. I've used Emblematics successfully for many years.

http://www.emblematics.com/index.html
http://www.cheappins.com/
http://www.pincentives.com/index.html
http://www.janway.com/default.htm

The local FOP and FOPA groups have those tabs like you are talking about. You might check with them in your area. also to see who they use.

Thank you so much guys. I have passed the information on to our region's committee chairman.

Wayne