I am trying to install a "hot choke" or auto choke (passenger side of carburetor) on a 1955 Buick Special (262 cu. in.) 4 door sedan. I don't know if the cylinder/ball bearing are installed properly. Can anyone offer any guidance on this? Or, if anyone knows where I could find the schematic for this engine, can you please contact me? Any guidance will be greatly appreciated!
I also need to find a passenger side chrome headlight hood and the two pieces of stainless steel molding on the rear passenger door and the piece over the back wheel on the passenger side.

Check ebay for the chrome it shows up there now and then